%LINK-5-CHANGED: Interface Serial0/0/1, changed state to upīefore enabling the routing protocol, Ping the segments to test the network connection. %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to up %LINK-5-CHANGED: Interface GigabitEthernet0/1, changed state to up R1(config-if)#ip address 10.1.1.1 255.255.255.252Ĭonfigure the interfaces of Cisco Router R2 in the same way. %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0, changed state to up %LINK-5-CHANGED: Interface GigabitEthernet0/0, changed state to up Router#conf tĮnter configuration commands, one per line. Open the Cisco Router R1 CLI command prompt and configure the GigabitEthernet0/0 and Serial0/0/0 interfaces according to the IP blocks you specify. Also, add comments to the workspace by defining IP address blocks, assigning IP addresses to computers. Open Packet Tracer and create the topology as shown in the image below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |